16 and gauge 2-1/2" load data

[ylwdog]

I'm sure this question has probably been asked before but I could not find it in my searches. Does anyone know where I can get load data for 2-1/2" 16 and 20 gauges ? I have been searching gun shows, ebay and other web sites for old reloading manuals without success.
Thanks for any help.
jb

[fullchoke16]

Pretty much any data on a 2 3/4" shell is going to work in a 2 1/2" load. The main difference is in the wad column and crimp type. I use roll crimps on short shells and the same wad and load as 2 3/4". Depending on what hull you use you might have to change the wad to get it all to fit.

[ylwdog]

Thank you for the info. I will give that a try.

[jentb737]

If you are using a PW375C reloading tool to load your short 16 gauge shells and using a once fired light purple 2 and 1/2 inch 16 gauge RST hull I can tell you what has worked for me.......Jent

[Twice Barrel]

Check in at 16GA.com. My two favorite loads are Cheddite or Federal hulls Gualandi 1621 wad Winchester 209 primers, 17.5 grains of Unique and 7/8th ounce of shot and Gualandi 1618 wad 19.5 grains of Unique and 1 ounce of shot. Both loads are roll crimped. the one ounce load is in the 1150 fps muzzle velocity and 8900 psi chamber pressure range. The 7/8th ounce load is about the same velocity but chamber pressure is less than 8000 psi.