Page 1 of 1
Sterlingworth forend question
Posted: Mon Jun 29, 2015 10:35 pm
by Mother ducker
Have a few hundred shells run through my new to me fox sterlingworth.feels like it's breaking in. I noticed cleaning it my forend has a slight wiggle while installed. Side to side and up and down.wondering if this is normal or I should have checked out. It wiggles enough to see movement between the forend iron and receiver. The spring is very strong while installing and disassembling the forend just feels like it hits a dead spot tension wise when it finally seats. Thanks
Re: Sterlingworth forend question
Posted: Thu Jul 30, 2015 6:05 pm
by Mother ducker
This was a problem,looked at and repaired,now tight as a witch! Replied to my own post for an update for the ones like me who " don't know"
Re: Sterlingworth forend question
Posted: Thu Jul 30, 2015 10:17 pm
by bbman3
Glad you got it fixed.Sorry I did not see your question.Was it the rear horizontal screw stripped out? Bobby
Re: Sterlingworth forend question
Posted: Sun Aug 02, 2015 10:13 pm
by Mother ducker
No I was told a poor fit from factory , this is a very early Utica gun. Not sure but I think to much metal was removed from fore end iron in fitting.