Safety Bar Alignment Pin

Post your questions or seek advise regarding gunsmithing, restoration, repairs, ballistics, etc, etc.
Commercial operations or businesses may not advertise nor appear to advertise their products or services, either directly, or indirectly by a second party, except for simple reference as a source for such products or services
Post Reply
JasonR
Posts: 8
Joined: Mon Dec 25, 2023 8:41 am
Has thanked: 4 times
Been thanked: 2 times

Safety Bar Alignment Pin

Post by JasonR »

So the round head alignment pin that runs between the two forks of the safety bar broke off on my Sterlingworth. Looks like it was originally a press fit pin, I'm thinking about drilling out the remainder of the pin then use a bottoming tap to put 2-56 threads in for a small screw as a replacement. Is this the best solution or are there any other ideas from the experts in the group?

Screenshot 2026-11-11 071624.jpg
Top
Post Reply

Return to “"Technicana" and Restoration Forum”