Part, or pic, needed

[Stan Hillis]

I'm in need of one of the original horseshoe shaped forend reinforcement parts that Savage used to repair, reinforce Fox forends on which the long no. 8 wood screw, that pulls the forend iron tight against the rear of the wood, had stripped out or no longer had any purchase.

I do not know if Savage made them in gauge specific sizes or not. I'm needing to repair a 20 ga. SWE. I have had excellent advise given freely to me by a member here, that this may be the best way for me to go to ensure that this issue never happens again, on this gun, that is used for hunting only. The ridge of wood between/under the ejector springs is broken away, and there is scant wood there on a 20 in the first place.

If one of the original parts isn't available I can make one myself if I have a good close-up photo. I began the process, yesterday, to make a piece to inlet at the bottom, to thread a machine screw into, but realized that the "legs" of the horseshoe shape are desirable to give additional purchase in the sides of the forend wood, because the wood at the bottom of a 20 ga. forend is so thin already.

Thanks in advance, SRH

[Silvers]

Stan I’m pretty sure I have one and will txt you a pic with dimensions when I get home later. frank

[Stan Hillis]

Thanks, Frank, but I just found one I didn't know I had. I was looking at an extra complete 12 ga. forend I have and it has one on it that I can copy, if I'm not able to buy one. I really appreciate the offer, though.

[Brian Dudley]

I have a new old stock one for a small bore if you end up still needing one.

[Stan Hillis]

I do, Brian. Thank you.

How is the best way to contact you about it?

SRH